A drilled plate of ferromagnetic material suitably coupled by coils of enameled copper wire fed by a DC power supply to 30V is considered in this paper. It is analyzed with finite element and later experiments are performed to validate the obtained results. After polishing the plate, two strain gauges for measuring the deformation along the x axis and along the z axis are installed. The values of strain are 5μm/m in z direction and -2μm/m in x direction. The experimental-numerical comparison shows that the laboratory results are lower than numerical, while signs and orders of magnitude are the same. It is concluded that the results of the FEM analysis can be considered acceptable because the orthogonality of the plane of the coils relative to the plane of the plate and because of the packing coefficient of copper. The position of the two coils is changed in order to found the optimal configuration which allows the maximum compressive stresses in the area around the hole; it is obtained using two coils joined (positioned above the hole) or using a single coil. Moreover numerical simulations are executed to verify the improvement of the fatigue life calculating the stress at the crack tip.

Barbaraci, G., Marannano, G., & Virzi' Mariotti, G. (2013). ANALYSIS OF THE EFFECTS OF MAGNETIC FIELD ON THE INDUCED STRESS IN DRILLED PLATES. INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES, 2013(9), 1425-1436 [http://dx.doi.org/10.1016/j.bbr.2011.03.031].

ANALYSIS OF THE EFFECTS OF MAGNETIC FIELD ON THE INDUCED STRESS IN DRILLED PLATES

BARBARACI, Gabriele;MARANNANO, Giuseppe Vincenzo;VIRZI' MARIOTTI, Gabriele
2013

Abstract

A drilled plate of ferromagnetic material suitably coupled by coils of enameled copper wire fed by a DC power supply to 30V is considered in this paper. It is analyzed with finite element and later experiments are performed to validate the obtained results. After polishing the plate, two strain gauges for measuring the deformation along the x axis and along the z axis are installed. The values of strain are 5μm/m in z direction and -2μm/m in x direction. The experimental-numerical comparison shows that the laboratory results are lower than numerical, while signs and orders of magnitude are the same. It is concluded that the results of the FEM analysis can be considered acceptable because the orthogonality of the plane of the coils relative to the plane of the plate and because of the packing coefficient of copper. The position of the two coils is changed in order to found the optimal configuration which allows the maximum compressive stresses in the area around the hole; it is obtained using two coils joined (positioned above the hole) or using a single coil. Moreover numerical simulations are executed to verify the improvement of the fatigue life calculating the stress at the crack tip.
Settore ING-IND/14 - Progettazione Meccanica E Costruzione Di Macchine
Barbaraci, G., Marannano, G., & Virzi' Mariotti, G. (2013). ANALYSIS OF THE EFFECTS OF MAGNETIC FIELD ON THE INDUCED STRESS IN DRILLED PLATES. INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES, 2013(9), 1425-1436 [http://dx.doi.org/10.1016/j.bbr.2011.03.031].
File in questo prodotto:
File Dimensione Formato  
IJSC-main.pdf

Solo gestori archvio

Descrizione: articolo principale
Dimensione 2.73 MB
Formato Adobe PDF
2.73 MB Adobe PDF   Visualizza/Apri   Richiedi una copia

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: http://hdl.handle.net/10447/70503
Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 1
  • ???jsp.display-item.citation.isi??? 1
social impact