Water activation products generation and transport in DEMO divertor

In water-cooled nuclear reactors, the issue of neutron-activated products transport along the primary heat transfer system (PHTS) is very demanding, as it is a coupled neutronic/fluid-dynamic problem requiring a challenging balance between accuracy and reasonable computational time. This work addresses the transport of water activation products in large hydraulic circuits. Regarding the nuclear calculations, the assessment of the production rates of the radioisotope concentrations has been performed by Monte Carlo analyses adopting the MCNP5.1.6 code, while for the transportation calculations, an innovative method has been expressly developed. It foresees a one-dimensional nodalization, in a MATLAB-Simulink environment, of the hydraulic circuit considered with a computational fluid-dynamic (CFD) characterization (by ANSYS CFX code) of the nodes under neutron flux, that is the components where radioisotopes are formed, and the highest gradients of concentration are present. The method was compared with one-dimensional models not supported by fluid-dynamic analysis. The results of this comparison showed that in cases involving fairly complicated geometries and radioisotopes with a small half-life, CFD analyses are necessary to achieve adequate accuracy. The procedure was applied to very large and rather complex hydraulic circuits like the divertor PHTSs of DEMO fusion reactor to obtain the concentrations of the activation products of the water constituents (16N, 17N, 19O, 14C, 41Ar) along such systems.