Hydrocarbons removal from synthetic bilge water by adsorption onto biochars of dead Posidonia oceanica

Bilge waters are wastewaters produced on boats during navigation and usually contain hydrocarbons and oils. They cannot be directly released into the sea if not below a hydrocarbons concentration limit set by current legislation. Appropriate oil in water separator (OWS) systems can be installed on board boats to remove hydrocarbons from bilge water allowing their spillage into the sea. These systems may contain an adsorption step on a suitable adsorbent. Here, biochars produced from pyrolysis of dead Posidonia oceanica, pristine or chemically activated, have been tested as hydrocarbons adsorbents. Adsorption experiments with aqueous dispersions simulating bilge waters containing a marine gas oil (MGO) fuel for boats, a surfactant, and different NaCl concentrations were carrying out. The hydrocarbons concentrations before and after adsorption have been directly measured by using the reverse phase HPLC technique coupled with a fluorescence detector. These measurements are very fast and their reliability was verified by re-measuring the hydrocarbons concentrations of some samples with the GC–MS-MS technique, according to one of the traditional methods for hydrocarbons determination in emulsions. Different isotherm equations were used to fit the adsorption data. The biochars were characterized from the chemical-structural point of view by means of several instrumental techniques.